Witt Machine Witt Machine Photo of Custom Clamp-On Muzzle Brake

Write Review

Clamp On Muzzle Brake


Purchased the MB1 Muzzle Brake in Black Ceracote to mount on my Remington 700 chambered in .308 Winchester. I measured the OD of the barrel at the muzzle end (.660") with my calipers and took another measurement 1-1/2" from the crown of the muzzle (.662") per the instructions on the Website and placed the order - I received the product within a week. Upon inspection, I can only comment on how well this Muzzle Brake was machined and finished - literally, a work of art. It fit like a glove on the end of the barrel without any perceptible play or "slop" - very impressed! I used blue Loctite and incrementally torqued the 4 screws to the recommended torque (DO NOT OVER-TIGHTEN!) and took it out to the range. My rifle was already zeroed at 100 yards and my groups were just as tight with the Muzzle Brake installed as they were prior without the Muzzle Brake. At 200 yards shooting from the prone position with a bipod, my groups actually tighted-up - probably because of the significantly reduced recoil. Although there are reports of the increased blast noise associated with the use of Muzzle Brakes of this design, I did not - nor did my fellow shooters on either flank notice anything out of the ordinary with the blast noise of the .308 Win - any shooter should use proper hearing protection, anyway, so I think that the noise comments are a non-issue. Fantastic product and it Looks Cool Too! I highly recommend this Muzzle Brake to my fellow shooters throughout the USA. F J Thomas - NRA Training Counselor and CMP Master Military Rifle Instructor.
Date Added: 09/22/2017 by Frank J Thomas Jr
Copyright © 2018 Witt Machine